Ideal scissors, small and maneuverable D15A in sales box

For continuous, straight and curved cuts
The extremely small forged heads have optimized blade geometry is very manoeuvrable
Optimized leverage ratio with smallest design guarantees 100 % performance with low force input
ERGO handle for low-fatigue work
Right or left cutting available

Technical data

Areas of application

Safety instructions

Manual sheet metal snips may only be used to cut thin sheets of soft metals or steel. They are not suitable for cutting through round or rectangular section metal shapes such as wires.
Cutting tools may only be used manually without using any auxiliary tools.
Always wear safety goggles and gloves when working. Cut parts can injure workers and bystanders.
Improper use can cause personal injuries or material damage.
Disconnect the connection to the power supply when carrying out work on electrical equipment. Otherwise, you may get an electric shock.
Always cut away from the head when using snips and knives.
Always store cutting tools with the cutting edges closed and in a location where they are clearly visible. The handle must be pointing towards you.
Store cutting tools separately. This saves the cutting edges and your fingers.
Sharpen cutting tools regularly. Blunt tools increase the risk of injury and require more force for the same cutting performance.

Material / Surface

Care instructions

Clean the rails with solvent
Rub the cutting edge with a lightly oiled cloth (remove material dust) in regular cycles, depending on the degree of soiling
Regularly oil the screw connections on the inside of the blade
Rusty or scratched cutting edge, gently scrape it off with an oil stone
If the snips exhibit too much play, adjust the screw. (It must still be possible to open and close the shears easily)